The service life of Berkey® filters has been calculated according to laboratory tests. It is different depending on the type of filter.

• For Black Berkey® black filters, see this link: How long do Black berkey® filters last?
• For PF-2™ filters, see this link: What is the life of PF-2™ filters?
• For shower filters, the filtration capacity is 113 400 liters of water, or approximately 1890 showers.

Black Berkey® filters act in a "mechanical" way by retaining pollutants in the millions of micro channels that compose it and also thanks to other layers, such as the ion exchange membrane or activated carbon. For the purely mechanical part, it is estimated that the filtration fineness is below 24 nanometers (0.024 microns) which corresponds to the size of certain viruses that are effectively filtered such as MS2 or Fr Coliphage.

Even if it is impossible to give the exact composition of the filters, for obvious reasons of industrial secrecy, what can be said is detailed by following this link: What is the composition of Black Berkey® water filters?

Berkey® systems are not just water filters. They are above all water purifiers that are effective against a large number of pollutants, viruses and bacteria, the list of which is published and available through analyses that have been carried out by an independent laboratory following NSF standard protocols. These results are public and can be found here: list of pollutants removed by Berkey® filters.

When you want to filter water whose composition is totally unknown to you, and unless you have no other choice (emergency situation for example), we advise you to make an initial analysis in order to verify that you are not in the presence of a specific pollution that the Berkey® system would not be able to filter correctly. This could be a specific industrial pollution, a resurgence of an old pollution, an important radioactive pollution, etc... The risk is certainly low, but the manufacturer Berkey® itself recommends to filter the safest possible water or to do some tests beforehand. This does not detract from the outstanding performance of Berkey® filters and their real ability to clean water. It is just a precautionary principle.

Whether or not you have decided to do a preliminary water analysis, there are two things to check:

- It is important to make sure that the seal is perfect during the first filtration. The butterfly nuts and blocking plugs must be tightened sufficiently so that the filtered water only comes out of the end of the threaded rods and not around the nuts or plugs. To do this, you must lift the upper tank and visually check that everything is correct.
- It is also recommended to do red dye test after the second filtration.
- None of the elements, except for the inside of the upper tank to be filled and the upper part of the filters, should come into contact with contaminated water.
- Be careful, if you wash your hands with this water, you will contaminate any of the elements by touching them: tap, filters, lower tank.
- Black Berkey® filters, under these conditions, should not be primed with contaminated water. You must prime them with the Black Berkey® Primer pump. This is a mandatory tool in these conditions.
- Discard the first 2 filtrations.

You can also consult this this topic for more information on rainwater filtration.